Special design

Sheath in stainless steel for very corrosive environments like injection moulding of details in PVC, which also allows a higher temperature and surface loading 7W/cm2. Thermo sensor type J for temperature regulation. Alternative connections see above.

 

Assesmbly instruction

Socket head cap wrench 4 mm is used.

It is very important that the nozzle element is assembled thightly to avoid any internal voids between element and for instance nozzle of an injenction moulder. After the first heating the nozzle element must be after-stretched. Bending of the connection cable close to the element to be avoided. Remaining plastic material at element surface can be removed by heating to melting point. Avoid blows at the element and take good care when removing plastic.

BACKER ALPE · Fco.I. Madero No. 2137 Pte. Col. Centro, C.P. 64000 Monterrey, N.L
Mexico · TEL: +52-81 1133 8753 · [email protected] · Corp. reg: 5560530569

2018 Backer Alpe. All rights reserved.